What is default omnia NAT mapping and filtering type

General discussion
1

What type of mapping and filtering is done by turris omnia? Is it configurable?
I’m asking for an answer as defined by https://datatracker.ietf.org/doc/html/rfc4787#section-5
e.g., “Endpoint-Independent Mapping” and “Address and Port-Dependent Filtering”

2

I think by default it only uses port filtering. But you could set up NAT rules with LUCI here:
https://omnia.lan/cgi-bin/luci/admin/network/firewall/snats

3

This topic was automatically closed after 60 days. New replies are no longer allowed.