Omnia-mcutool --update

Software SW help
1

Hi,

with Omnia 6.4.3 Update we had this in the changelog:

• omnia-mcutool: updated to version 0.2 and packaged firmware

How do we use it? Should we use it? Just run omnia-mcutool --update?

2
1 Like
3

So this is still Open. Does that mean we should wait with the update until the status is Merged?

4

Please, what’s the status here? I am still on 6.4.2 as I am waiting for instructions announced here:

We will write up something about it in few days with a short howto.

That’s 20d ago. Are there any instructions yet?

1 Like
5

You should not block the update. It only enables new options, it does not update the MCU (AFAIK).

6

As the patch now has the status Merged, I upgraded to 6.4.4, then ran:

opkg install omnia-mcutool
omnia-mcutool --upgrade

Seems everything went fine.

root@omnia:~# omnia-mcutool -v
Bootloader version:  2174b570bd5c038e83e75026a30eb7250bce7ccc
Application version: 67eddc9540526d0a9d9660f7a7867af9a28a68d6
MCU type: GD32
Board firmware type: gd32-rev23
Features: 0x1f6e
  EXT_CMDS
  WDT_PING
  LED_STATE_EXT
  LED_GAMMA_CORRECTION
  NEW_INT_API
  FLASHING
  NEW_MESSAGE_API
  BRIGHTNESS_INT
  POWEROFF_WAKEUP
  CAN_OLD_MESSAGE_API
Application firmware length: 16356 Bytes
Application firmware checksum: 0x54af5d39
7

This topic was automatically closed 3 days after the last reply. New replies are no longer allowed.