Hi,
I’ll take the right thread now, hre is my config with connected clients:
root@Turris-Omnia:/sys/kernel/debug/ieee80211/phy0/ath10k# cd /sys/kernel/debug/ieee80211/phy0/ath10k && cat fw_stats
ath10k PDEV stats
=================
Channel noise floor -103
Channel TX power 46
TX frame count 35839658
RX frame count 98281067
RX clear count 147855232
Cycle count 3579580547
PHY error count 3320
RTS bad count 6816114
RTS good count 479492105
FCS bad count 748229011
No beacon count 0
MIB int count 32897
ath10k PDEV TX stats
=================
HTT cookies queued 1583466
HTT cookies disp. 1583466
MSDU queued 2162789
MPDU queued 1924915
MSDUs dropped 0
Local enqued 579323
Local freed 579323
HW queued 1854525
PPDUs reaped 1854525
Num underruns 0
PPDUs cleaned 0
MPDUs requed 97978
Excessive retries 57152
HW rate 216
Sched self tiggers 577
Dropped due to SW retries 0
Illegal rate phy errors 0
Pdev continuous xretry 0
TX timeout 0
PDEV resets 3
PHY underrun 0
MPDU is more than txop limit 0
ath10k PDEV RX stats
=================
Mid PPDU route change 24
Tot. number of statuses 2859303
Extra frags on rings 0 0
Extra frags on rings 1 204
Extra frags on rings 2 241
Extra frags on rings 3 0
MSDUs delivered to HTT 2859303
MPDUs delivered to HTT 2859302
MSDUs delivered to stack 1778047
MPDUs delivered to stack 1778047
Oversized AMSUs 0
PHY errors 15156030
PHY errors drops 3285
MPDU errors (FCS, MIC, ENC) 100528
ath10k VDEV stats (0)
=================
ath10k PEER stats (3)
=================
Peer MAC address 4c:5e:0c:13:ff:ac
Peer RSSI 0
Peer TX rate 0
Peer RX rate 0
Peer RX duration 0
Peer MAC address 5c:51:4f:47:9d:9d
Peer RSSI 35
Peer TX rate 780000
Peer RX rate 650000
Peer RX duration 0
Peer MAC address 80:01:84:d6:4f:fb
Peer RSSI 55
Peer TX rate 433300
Peer RX rate 6000
Peer RX duration 0
here is my dmesg output:
[ 14.504919] pci 0000:00:01.0: enabling device (0140 -> 0142)
[ 14.510837] ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
[ 14.683298] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/pre-cal-pci-0000:01:00.0.bin failed with error -2
[ 14.694032] ath10k_pci 0000:01:00.0: Falling back to user helper
[ 14.703770] firmware ath10k!pre-cal-pci-0000:01:00.0.bin: firmware_loading_store: map pages failed
[ 14.712896] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/cal-pci-0000:01:00.0.bin failed with error -2
[ 14.723286] ath10k_pci 0000:01:00.0: Falling back to user helper
[ 14.732769] firmware ath10k!cal-pci-0000:01:00.0.bin: firmware_loading_store: map pages failed
[ 14.749753] ath10k_pci 0000:01:00.0: qca988x hw2.0 target 0x4100016c chip_id 0x043202ff sub 19b6:d03c
[ 14.759025] ath10k_pci 0000:01:00.0: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
[ 14.768631] ath10k_pci 0000:01:00.0: firmware ver 10.2.4-1.0-00029 api 5 features no-p2p,raw-mode,mfp,allows-mesh-bcast crc32 88595bb8
[ 14.813376] ath10k_pci 0000:01:00.0: board id is not exist in otp, ignore it
[ 14.820484] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/QCA988X/hw2.0/board-2.bin failed with error -2
[ 14.830952] ath10k_pci 0000:01:00.0: Falling back to user helper
[ 14.840633] firmware ath10k!QCA988X!hw2.0!board-2.bin: firmware_loading_store: map pages failed
[ 14.849571] ath10k_pci 0000:01:00.0: board_file api 1 bmi_id N/A crc32 bebc7c08
[ 15.976677] ath10k_pci 0000:01:00.0: htt-ver 2.1 wmi-op 5 htt-op 2 cal otp max-sta 128 raw 0 hwcrypto 1
[ 16.061071] ath: EEPROM regdomain: 0x0
[ 16.061076] ath: EEPROM indicates default country code should be used
[ 16.061079] ath: doing EEPROM country->regdmn map search
[ 16.061083] ath: country maps to regdmn code: 0x3a
[ 16.061086] ath: Country alpha2 being used: US
[ 16.061088] ath: Regpair used: 0x3a
and this, with ethtool:
root@Turris-Omnia:/sys/kernel/debug/ieee80211/phy0/ath10k# ethtool -i wlan0
driver: ath10k_pci
version: 4.4.106-1e4a549d177ab3da12b2052
firmware-version: 10.2.4-1.0-00029
expansion-rom-version:
bus-info: 0000:01:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no
and this:
root@Turris-Omnia:/sys/kernel/debug/ieee80211/phy0/ath10k# iw dev wlan0 station dump
Station 80:01:84:d6:4f:fb (on wlan0)
inactive time: 680 ms
rx bytes: 3635717
rx packets: 26278
tx bytes: 19015442
tx packets: 23807
tx retries: 0
tx failed: 0
signal: -33 dBm
signal avg: -38 dBm
tx bitrate: 6.0 MBit/s
rx bitrate: 6.0 MBit/s
authorized: yes
authenticated: yes
preamble: long
WMM/WME: yes
MFP: no
TDLS peer: no
Station 5c:51:4f:47:9d:9d (on wlan0)
inactive time: 0 ms
rx bytes: 8741363
rx packets: 70198
tx bytes: 112956365
tx packets: 102458
tx retries: 0
tx failed: 22
signal: -61 dBm
signal avg: -59 dBm
tx bitrate: 6.0 MBit/s
rx bitrate: 650.0 MBit/s VHT-MCS 7 80MHz short GI VHT-NSS 2
authorized: yes
authenticated: yes
preamble: long
WMM/WME: yes
MFP: no
TDLS peer: no
I hope that this info will help you