Quectel EP06 configuration

Software SW help
1

Hi,

I’m trying to get the Quectel EP06-E LTE modem working in my Omnia. Unlike earlier Quectel modems, the EP06 seems to provide both PCI-E and USB interfaces. Initially, it was not recognised at all. I couldn’t see anything in lspci or lsusb. I taped the PCI-E pins (23, 25, 31, 33) as per some instructions I found. The modem is now recognised as a USB device:

Bus 001 Device 002: ID 2c7c:0306

I can see four USB serial ports under /dev. However, cdc-wdm0 is missing.

I tried putting the modem in QMI mode using AT+QCFG="usbnet",1, but I still can’t see the cdc-wdm device.

AT+QCFG="usbnet",2 seems to put the modem in MBIM mode (according to dmesg). /dev/cdc-wdm0 exists, but I have no idea how to configure the modem or even where to start.

Any ideas?

Note that an EC25-E works perfectly fine in the same Omnia.

Thanks!

2

Hi

Have you find solution? I’ve order this pcie card…

Thank you

3

No, I haven’t :frowning: It’s been sitting in my drawer.

4

Hum. Do you know if ec25-e is supported ?

5

That’s what I currently have in my Omnia, and it works pretty well. I’m getting ~80 Mbps over LTE.

6

I’m going to close this ticket because right now, we have 3 threads about Quectel EP06.
Let’s continue the discussion here:
https://forum.test.turris.cz/t/support-for-quectel-ep06-lte-a